laminated core

英 [ˈlæmɪneɪtɪd kɔː(r)] 美 [ˈlæmɪneɪtɪd kɔːr]

叠片铁(磁)心

电力



双语例句

  1. Comparison of Three Dimensional Wound Core Transformer to Traditional Laminated Core One
    立体卷铁心变压器与传统叠铁心变压器比较
  2. The device can complete the automatic production of the laminated fully-straight seam iron core sheets.
    本横剪线可完成叠片式全直接缝铁芯片型的自动生产。
  3. The paper has analyzed the influence of the laminated stator core seam on the electromagnetic flux distribution, as well as the electromagnetic flux change rule when seam is non-uniform.
    该文分析了定子铁心叠片接缝对电机磁通分布的影响,以及接缝不均匀时电机磁通的变化规律。
  4. Novel current sensor based on GMI effect in serial laminated amorphous ribbons embedded in the air gap of a toroidal core
    磁芯气隙中串联层叠非晶带GMI效应电流传感器
  5. It is also shown that laminated core is a good way to reduce the induced eddy current, which is helpful to enhance the interrupting capability.
    另外计算结果还表明,采用铁芯叠片的方法可有效地抑制涡流,这有利于提高该真空灭弧室的开断能力。
  6. The principle of reducing the no-load loss, no-load current and noise of five-step laminated core is analysed. The analytical result shows that the structure adopted five step laminated core can improve no-load performance obviously.
    分析了五级接缝铁心降低空载损耗、空载电流及噪声的机理,指出铁心采用五级接缝铁心结构能够大幅度提高变压器的空载性能。
  7. The material cost of the transformer is comparied with the one of S11 series distribution transformer with plane laminated core.
    RL系列立体卷铁心配电变压器的特点,并将该变压器与S11系列平面叠铁心配电变压器进行了材料成本比较。
  8. The technique economic analysis of type of S_ ( 11) laminated iron core distribution transformers
    S(11)型叠铁心配电变压器技术经济分析
  9. The experimental results show that in the experimental ranges of temperature ( 0~ 70 ℃) and frequency ( 1~ 200Hz), the temperature characteristics of both the structural stiffness and internal friction of alternately laminated structures are better than those of the centralized damping core layers structures.
    实验结果表明:在实验温度(0~70℃)和频率(1~200Hz)范围内,交替层合结构的内耗和刚度的温度特性均优于集中阻尼芯层结构;
  10. Generally, the stator core fault includes loosening of effective laminated core, damage of patch insulation, deflection or drop of end press finger, vibration of core, excessive heat of end, damage of stator core caused by earthing of wingings.
    定子铁心故障一般分为有效铁心压装的变松、片间绝缘损坏、铁心端部压指压偏或脱落、铁心振动或噪声超标、端部发热、绕组接地引起的定子铁心损坏等。
  11. No-Load Performance of Five-Step Laminated Core Transformer
    五级叠片铁心变压器的空载性能
  12. Several advanced energy-saving methods of power transformer are analyzed and summarized in this paper including the techniques of multi-step laminated core, amorphous alloy core and high temperature superconducting winding.
    本文分析与总结了几种具有发展前景的变压器节能新技术,包括采用多级接缝铁心结构与非晶合金铁心材料,绕组采用高温超导技术。
  13. Local deformation behavior of laminated sandwich plates with a flexible core
    复合材料层合夹芯板局部变形行为研究
  14. In this paper, the 3D finite element analysis is used to study on the stator modal shapes and natural frequencies of large induction motor. The influence of laminated core and winding on the natural frequencies and modal shapes of the stator are investigated.
    文中利用3D有限元软件研究了定子模态和固有频率,分析了定子叠片结构、绕组对大型异步电机定子固有频率和振动模态的影响;
  15. Brief Discussion on Advantages of Step-Lap Laminated Core
    浅谈阶梯接缝叠铁心的优越性
  16. Hamilton Canonical Equation Theory of Laminated Structure and Application in Vibration Analysis of Turbo Generator Stator Core
    叠层板结构Hamilton正则方程理论及其在发电机铁芯振动分析中的应用
  17. In the research, typical structures of the new-type glued laminated bamboo are vertical core pressed panel and horizontal pressed panel.
    在本研究中,竹集成材家具基材典型结构为竹质立芯板材结构和横拼板材结构。